|Contact Us for Quotation||Email：firstname.lastname@example.org||Whatsapp: +8618620373879|
|Products Guide Map: Click|
MEWOI-JF9300N 10KV High voltage insulation resistance tester with printer,touch screen,Megôhmetro digital de 10kV
The MEWOI-JF9300N is a smart, 10kV insulation tester and analyzer with Printer and Touch Screen.The measurement of insulation resistances up to 1000GΩ, its advanced features allow to automatically measure both the Polarization Index and Dielectric Absorption Index, thus significantly simplifying testing of transformers.
This insulation tester is a portable, battery-powered equipment. Test voltage may be chosen from 500 V to 10kV in 500V increments. High output current, short circuit current greater than 5mA.Due to its measurement principle (actual voltage and current readings) the accuracy of resistance measurement is not affected by any test voltage error.
The absorption ratio and polarization index are calculated automatically, and the data of 15 seconds, 1 minute and 10 minutes per minute are stored automatically for easy analysis.
The MEWOI-JF9300M is powered using a rechargeable battery and has an automatic charger that may be connected to 180 - 270V mains supply. The cabinet is strong and lightweight, easy to carry, impact-resistant and suitable to be used under severe weather conditions. Thus the megohmmeter supplies very reliable and accurate measurements both in laboratory and out in the field.
|1,High Definition LCD Color Touch Screen, thermal printer|
|2,Intelligent High-voltage insulation resistance tester, with 5 ranges: 500V, 1000V, 2500V, 5000V, 10KV, test up to 1000GΩ.|
|3,Strict accordance with the safety standards for design|
|4,Insulation resistance range 1000GΩ @ 10KV|
|5,Short circuit current can be adjusted, maximum 5mA|
|6,Strong anti-interference ability, can meet the field operation of ultra-high voltage substation.|
|7,Discharge automatically after test and monitor the discharge process in real time.|
|8,Automatic display polarization index (PI), Induced electric absorption ratio test values (DAR).|
|9,With rechargeable battery and charger, it can be fully charged for 6 ~ 12 hours when no backlight is used.|
|10,real-time voltage and current display|
|11,Scale and digital dual display|
IEC 61010-1 CAT.IV 600V
IEC 61326 EMC specification: test, control and electrical equipment for testing
IEC60529 IP64 （Outer closed state
500 V, 1,000 V, 2,500 V, 5,000V,10000V directly, selectable. 500 V to 10kV in 500V increments.
|Maximum resistance reading||1000GΩ @ 10kV.|
|Short circuit current||5mA|
|Megohmmeter basic accuracy||± (10%+5Dgt) of reading from 1 MΩ up to 1000GΩ.|
Automated Polarization Index calculation.
Automated Dielectric Absorption Ratio calculation.
Step Voltage Test.
|Display||3.5inch Color Touch Screen|
Internal rechargeable battery.
|Battery Life||6~12 hours when without backlight|
|Battery Charger||180～270VAC ,50Hz/60Hz±1%|
Operating temperature range
-5 °C to 50 °C.
Storage temperature range
-25 °C to 70 °C.
95 % RH (non condensing).
|Dimension||280 x 260 x 130 mm|
2.The high-pressure silica gel test line (red, green and black one)*1
3. AC power line*1
4. Operating manual*1
|Model No./Link||Voltage Range||Resistance Range||Resolution||Accuracy||Short circuit current|
|1MΩ～200MΩ: ± ( 3.0%+5 ), 200MΩ～10GΩ: ± ( 5.0%+5 ), 10GΩ～200GΩ: ± ( 10.0%+5 )||-||-||-||-|
|5KV||500GΩ @ 5kV.||1 MΩ||± (10%+5Dgt)||5mA||√||Internal rechargeable battery||Printer+Touch Screen|
|10KV||1000GΩ @ 10kV.||1 MΩ||± (10%+5Dgt)||5mA||√||Internal rechargeable battery||Printer+Touch Screen|
|10KV||10TΩ @ 10kV.||1 MΩ||± (10%+5Dgt)||5mA||√|
or AC Power Supply
|15KV||20TΩ @ 15kV.||1 MΩ||± (10%+5Dgt)||5mA||√||Rechargeable battery |
or AC Power Supply
|20KV||20TΩ @ 15kV.||1 MΩ||± (10%+5Dgt)||5mA||√||Rechargeable battery |
or AC Power Supply